The HP G4-1016TX notebook is a computer that went on sale in 2011. It has been seven years since then, and laptop fans certainly have some minor problems,Such as excessive noise, excessive accumulation of dust, and fan damage. At this time, we need to replace a new fan to keep the computer running. Disassemble and replace the fan as follows.

       1, first prepare the disassemble tool and new fan. Tools include screwdrivers and cards. If you need to remove dust or change grease, you can also prepare related tools in advance. Then start disassembling.

       2, first cut off the power, remove the battery, use a screwdriver to remove the back cover of the set screw, remove the cover.

       3, remove the hard drive and memory. Loosen the hard disk fixing screw, remove the HP G4-1016TX laptop hard disk, and loosen the clips on both sides of the memory module to remove the memory module.

       4, wireless network card and keyboard. After loosening the screws in the figure below, lift the corner of the wireless network card and gently remove it. Then unload the keyboard fixing screw, flip the notebook to the front to open, insert the card into the gap of the C surface, and repeatedly shake, the keyboard can be automatically detached, but be careful of the rear of the keyboard, take the row before taking the keyboard line.

       5, then remove the C side and the motherboard, first pull the white, blue and purple data lines in the figure below, the method and uninstall the keyboard data line are the same, are dial up and draw out. Then use the card to open the C side to see the back of the motherboard. By the way, remove the cables and screws on the 1-6 position on the motherboard. The order is not limited. The No. 6 is the small screw of the fan. Remember the order, it is recommended to take pictures first.

       6, remove the fan. Use a screwdriver to loosen the heat sink's fixing screw, and then loosen the fan screw. Do not install the new fan first. Use a cleaning tool to clean the internal dust again. The GPU and CPU can also re-apply new grease and install a new fan.

       7， Reassemble the HP G4-1016TX notebook by following the reverse procedure above and finally starting the test.

Disassemble summary: To disassemble the HP G4-1016TX notebook, replace the fan, you need to remove a lot of screws, the specifications and installation location of these screws are not the same, it is recommended to take a photo before screwing, when the final assembly notebook, to ensure that the various row The lines were reconnected.